Rf Hardware Test Engineer

This is where I do my RF hardware testing. I’m located at Door Number 15 on the 1st Floor of the 7th B Main in BTM Layout, 1st Stage. I’m staying with Syed Safiulla. Bangalore is a busy place for this kind of work, so being in BTM Layout is actually quite convenient. The workspace is basically a room filled with testing gear and different hardware components. I spend a lot of time checking boards and making sure the radio frequencies are within the right specs. It's not a big corporate lab, just a practical spot where I can get things tested properly. Sometimes the noise from the street gets in, but you get used to it after a while. I handle the testing myself. It takes a lot of patience to go through all the test cycles, especially when a piece of hardware is acting up. I’ve been in Bangalore for a bit now, and this setup works well for what I need to do. It’s a simple life, mostly focused on the technical side of electronics. If someone needs a board checked or some RF parameters verified, this is where it happens. I don’t have a fancy sign outside, just the address. Most of my work comes from people who know I have the right equipment and the time to do a thorough job.