Metal Art Engineering Works

Metal Art Engineering Works is based out of Sudguntpalya, specifically at 61/2. It is a workshop where we spend most of the day cutting, welding, and bending metal. The air usually smells like iron and burnt sparks. It is a noisy place, so we have to shout sometimes to hear each other over the grinders. We make all sorts of things, from gates to small brackets. We do not have a showroom with fancy lights. You just walk into the shop and see what we are working on at the moment. There is a lot of scrap metal piled in the corner that we will get to eventually. The floor is concrete and always has a bit of dust on it. We have been at 61/2 for a good while, so we are pretty settled in Sudguntpalya. It is just us and our tools. Some jobs are simple and take an hour, others take all week and leave us exhausted. We do not use any high-tech robots; it is mostly just hands and old machines that still run fine if you treat them right. We keep a ledger on a dusty desk to track our orders. It is not a complicated setup, but it gets the job done for whoever stops by. We are usually there from morning until the sun goes down, just working through the pile of tasks we have lined up for the week.