Bhavya Automatic Systems

Malla Talai is where we set up shop, specifically in Sanjay Colony, Rata Khet 10. It’s a bit of a climb to get out here, but it’s a good place to work. Bhavya Automatic Systems is basically a workshop where we deal with all sorts of mechanical and electronic bits. There’s always some project taken apart on the main bench. We deal with sensors, motors, and things that are supposed to move on their own. Sometimes they don't, and that's why we're here. The floor is usually covered in wire clippings and small screws that I’m sure I’ll need later. It’s a bit messy, but we know where everything is. My neighbor often pops in to complain about the noise when we're testing something, but we get along fine. We’ve been in Sanjay Colony for a few years now. The light in the morning is great for soldering, so I try to get the delicate work done then. By midday, it gets pretty warm in here, so we slow down a bit. We aren't a big factory or a high-tech lab. We’re just a small crew in a dusty room making sure things work like they’re meant to. It takes a lot of patience to figure out why a system is glitching. We just keep poking at it until it behaves. It’s a living, and it keeps the brain busy even when the work is difficult.