Universal Spiral Stair Case Engineering & Fabrication

Running a fabrication shop in Borabanda means you deal with a lot of noise and iron dust every single day. We are located over at 14-1-127/8/A in Allapur, right near the J. K. Point Hotel, so there is always a lot of traffic passing by. It is a bit cramped in the workshop because spiral staircases take up a lot of room even before they are put together. You have to be careful where you step because there is usually some scrap metal or a welding lead on the floor. My clothes always have little burn holes from the sparks. It is hard work, especially when the sun is beating down on the roof and the welding torch is going. We spend most of our time measuring pipes and cutting steel plates to get the curves right. It is not the kind of job where you stay clean. By the end of the shift, my face is usually covered in soot. Sometimes a customer comes by the hotel and then finds us tucked away back here. We don't have a fancy showroom, just the tools and the heavy benches where we do the bending. It is loud and hot, and the smell of burnt metal is always in the air. We just focus on getting the stairs built right so they don't wobble. It is just a regular day of cutting and joining metal in Borabanda.